If the door does not open close turn power off for 15 seconds then switch on.
Stanley sliding door wont stay closed.
Tighten the hinges first if you find that the latch contacts the strike plate too high or too low make sure all the door s hinge screws are tight.
From the back of the door first draw a line around the latch so you can re assemble and not have to mess with re aligning the door.
Stanley automatic sliding doors are designed to not operate in the event any of the door panels are swung out.
I can get it now to stay closed but i know on built in sliding door wardrobes they come with a catch soft close mechanism is there anything like this for these magnet doors sure they are stanley please.
Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends.
It s really annoying when a sliding door won t shut completely but adding a couple magnets can help it shut all the way every time.
Your sliding door might be able to latch if you hold it and.
Turning this screw raises or lowers the roller.
I used some blocks of wood but a floor jack would have been more adjustable.
The best way to confirm that the doors are not swung out is to inspect each door leaf.
Next place a towel over a floor jack to protect the door.
If that doesn t solve the problem try this trick.
Your sliding door might be able to latch if you hold it and lock.
Support the bottom of the back of the door with the jack.
Adding a couple of magnets can help it shut all the way every time.
When the sensor is triggered an led lights up on the sensor cover.
Crouch down out of the sensor s path and see if the inside sensor s led is lit up.
For the following steps turn power off.
If the door becomes even harder to open turn the screw in the opposite direction.
Give the screw a clockwise turn and test to see whether the door slides easier.
Remove one of the screws on the jamb side of the hinge and drive in a 3 in.
Doors stay open and will not shut all automatic sliding doors feature sensors.
Overhead interior exterior sensor zones are clear and there are no items in the pathway of door.
Typically most automatic door sensors feature a light display.
Function switch is set to automatic aut.
Swing out each door leaf and firmly snap it back into place.
